- Adjustable dropout/pull-in voltage differential
- Adjustable time delays
- Works alone or with other CANPower units
- Very low power consumption
- Available in 12V or 24V
- Easy to install
A member of the CANPower family, this unit can be connected to other CANPower units by CANbus to run in tandem with them, or can be installed as a stand alone component.
Easy to install and fully installer programmable with very simple software through the optional interface unit. Standard unit comes with default settings which will suit most applications.
|
If vehicle battery voltage falls to an unacceptable level, the connected load switches off. A user-adjustable voltage sampling time delay prevents load cycling. The inbuilt adjustable hysteresis band sets the pull-in voltage higher than the dropout voltage, and this also prevents cycling. The pull-in voltage is normally set to 13.5 volts, so the engine must be restarted to automatically switch load back on.
The unit runs at around 2 milliamps when in passive mode so is exceptionally economical on power consumption.
The unit can also run external relays.
This unit can be adjusted on the bench or in-situ.
Typical Applications:
Police car radio - can flatten the battery in hours, disabling the car. This unit switches the radio off when battery voltage falls to a pre-set level, thus preventing it flattening the battery. Radio is re-powered when engine is started.
Fire appliance locker/interior lights - easily left on either by switch defect or door left open, and battery is drained. This unit prevents that happening.
|
